Where extension springs sit and how they work
If you look at the side of your garage door from the inside, you may see a long, narrow coil stretched out above each horizontal track, running roughly parallel to the ceiling. Those are extension springs. Unlike a torsion spring, which twists on a shaft above the door, an extension spring works by stretching. When the door is closed, the springs are stretched out to their longest. As the door rises, they contract and give up their stored energy, which helps lift the door.
A pulley at the front end of each spring and a cable running through it connect the spring to the door. The cable runs from the bottom bracket of the door, up the side and over the pulley, and back to a fixed point near the rear of the track. The pulley arrangement lets a spring that is relatively short do the work of lifting a much heavier door. At the other end, the spring is anchored to a bracket or to a hanger attached to the ceiling or track.
Both springs share the load equally, so they should be the same size and in similar condition. If one is weaker than the other, the door tends to lift unevenly and may twist slightly as it moves, which strains the track and rollers.
Where you tend to see them
Extension springs are most common on lighter doors, often single car doors and some older steel doors, and on homes built in earlier decades. They are simple to build into a door system and simple to install, which is why many builders used them. Many South Florida neighborhoods with homes from the middle of the last century and later still have original extension spring doors, especially in places with a lot of ranch style houses such as parts of Hollywood, Plantation, Hialeah and Kendall.
Heavier doors, insulated doors, doors with glass, and double wide doors more commonly use torsion springs, which handle large loads more smoothly. If you are not sure which you have, look at the area directly above the door opening. A coil on a rod with a cable drum at each end is a torsion system. Long springs along the sides of the horizontal tracks are extension springs.
Our page on torsion springs explains the other kind, and our guide to single and double garage doors touches on why the two door sizes often use different systems.
Why extension springs fail
Like all springs, extension springs fatigue with use. Each stretch and relax cycle flexes the steel, and eventually the wire cracks, usually near the end of the spring where the stress is greatest. Extension springs are also exposed to the ends of the track, the pulleys and the cables, so they take a lot of mechanical stress from the hardware they connect to.
Rust is a big factor in our climate. Springs on the side of the track are in the open air of the garage, where humidity is constant and salt may be present near the coast. Corroded springs can lose strength, stretch permanently and break sooner. A spring that has lost its tension may leave the door heavy, or one side of the door may sag as it moves.
Age also matters. An extension spring system installed when a house was built, and never replaced, has often been through a very large number of cycles. If the springs on your door look dull, stretched or covered in rust, and the door has not been serviced in a long time, it may be nearing the end of its useful life even if it still works today.
The role of safety cables
A broken extension spring is more dangerous than it sounds. The spring is stretched under tension, and when it snaps, the pieces can whip across the garage with force. They have been known to break windows, dent vehicles and injure people. For this reason, extension springs should have a safety cable threaded through the center of each spring and secured at both ends. If the spring breaks, the cable keeps the pieces contained and prevents them from flying loose.
Many older garages have no safety cables at all, or have cables that have rusted through or been disconnected. If you look at your spring and cannot see a thin cable running through its middle, that is worth mentioning when you call. A technician can add or replace the cables as part of a repair or inspection.
Our page on safety cables goes into more detail about how the cable works and what to look for. If you see a missing or frayed safety cable, treat the spring as a hazard and keep people away from the area until it is checked.
Signs that extension springs need attention
Because extension springs sit out in the open, many signs of trouble can be seen from the floor without going near the door. A spring that has snapped is easy to spot: one side hangs loose or is visibly in two pieces. A door that opens with a lurch or one side higher than the other can mean one spring is weaker. Springs that are stretched out of shape, with gaps between the coils even when the door is open, may have lost strength.
Sounds are another clue. A loud bang usually means a break. A repeated squeal or scrape as the door moves may point to dry pulleys or worn cable. If the door slams shut or does not stay open when partly raised with the opener disconnected, the system is out of balance.
Do not touch the springs, pulleys or cables while the door is in use, and do not try to adjust them. Even when the door is closed, the springs are carrying significant tension.
- One spring visibly broken or one side hanging loose.
- The door rising unevenly or twisting slightly as it moves.
- Heavy rust or flaking on the springs.
- Coils that have stretched and no longer contract fully.
- Missing, frayed or disconnected safety cables.
- Worn pulleys that squeal or wobble.
What not to do
Extension springs look simpler than torsion springs, and that tempts some owners to try replacing them. Please do not. The springs are under load even when the door is closed, and the way they are connected to the pulleys and the track means a slipped hook or a loose cable can release force suddenly. The door itself can also drop if the springs are removed or adjusted without the door being properly secured.
We will not describe the steps of removing or installing a spring here. What is safe for an owner is to observe, to keep people away from the door, and to call. If a spring has broken, do not run the door with the opener, and do not stand in the path of the springs or underneath the door.
Also avoid a common shortcut: replacing a single spring with a similar looking one from a hardware store. Extension springs are sized by the weight of the door, length and strength, and they must be matched on both sides. An incorrectly matched pair causes uneven lifting, extra stress on the cables and track, and extra wear on the opener.
What a technician checks and does
When a technician comes out for an extension spring problem, the first job is to make the door safe and secure. They then inspect both springs, the pulleys, the cables, the track hangers, the bottom brackets and the rollers. They test the balance of the door with the opener disconnected, to see whether the door stays in place at the middle of its travel. They also look at the safety cables, and note whether the door has them in good condition.
If a spring needs replacing, they will usually replace both, so the two sides match. The new springs are chosen to suit the door's weight and the way the system is set up. The technician installs them, checks and adjusts the cable so that the door lifts level, and tests the balance again. The opener limits and force settings are checked afterward, because a change in balance affects how the opener behaves.
Other worn parts that turn up during the visit are explained to you. You decide which to approve. The call ahead of time covers the service call charge, and anything beyond a simple repair is quoted after the technician has seen the door.
Should you convert to a torsion system
Some owners ask whether they should switch from extension to torsion springs. The answer depends on the door. Torsion springs generally operate more smoothly, hold up well on heavy doors and fail in a more contained way, because the spring is wrapped around a shaft. Converting a door is a more involved job, because it requires mounting a shaft, bearings, drums and a new cable arrangement, and the header must be strong enough to carry the load.
On a lightweight door in good condition, a repair with new extension springs and proper safety cables may be all that is needed. On an older door that is heavy for its springs or has been struggling, a conversion may be worth discussing. This is a decision for an on-site visit, where the technician can look at the door, the header and the track.
If you are planning a new door, read our guide to choosing a new garage door. A new door often comes with a spring system selected for it, which is a good opportunity to have the system designed correctly for your use.
Care and maintenance for extension spring doors
While you should not adjust extension springs yourself, there are low risk habits that help. Keep an eye on the springs when you walk through the garage. Look for rust, stretch and missing cables. Listen for changes in the way the door sounds. Make sure children and pets stay clear of the track area. If you see something that has changed, do not wait for the door to fail.
A professional inspection is the right place for lubrication and adjustment. Technicians know which points to lubricate and which to leave alone, and they can check that safety cables, brackets and pulleys are secure. Our guide to garage door lubrication explains in general terms what is and is not oiled, and our maintenance schedule suggests how often to have the door looked at.
In coastal areas and during the rainy season, check more often. A spring that is starting to rust can often be caught before it breaks. If you decide the time has come to have the system replaced, call, describe the door and what you see, and ask any questions you have about the safety cables. We will explain how the visit works and what happens next.
Pulleys, cables and hangers: the hardware around the spring
An extension spring is only as reliable as the hardware that holds it. The pulley at the front of each spring has a small wheel that turns on a pin, and if that wheel is dry, worn or cracked, it can bind and put uneven pressure on the cable. The cable itself runs through the pulley and attaches to the door, and it can fray where it bends. The hanger or eye bolt at the rear end holds the spring in place and carries the full load, so it must be solid and secure.
Many older installations have hardware that is original to the house and has been through years of humidity. Rusted pulleys and hangers can fail without warning. Because a spring that comes loose at one end can swing violently, loose or damaged hardware is as much a safety issue as a broken spring.
When technicians replace extension springs, they usually check and often replace the pulleys and cables at the same time. It saves effort to do it while the system is apart, and it avoids a repeat visit. Our page on lift cables explains what a good cable looks like and what signs of wear to expect.
Questions to ask before approving a repair
If your door has extension springs, a few questions help you understand the work. Ask whether both springs will be replaced and why. Ask whether safety cables will be fitted, and whether they will be new. Ask whether pulleys and cables look worn, and whether they should be replaced at the same time. Ask whether the door is balanced after the repair, and how the technician tested it.
Ask also whether this is a door where a torsion conversion would make sense, and what that would involve. You do not have to choose a conversion, but understanding the option helps you make a decision. If the door is old and light, a straightforward spring replacement may be enough. If it is heavy for its springs, the technician can explain the case for a different system.
A good technician welcomes these questions. When you call, tell us what you see and what the door does, and we will explain the service call charge and the next step.
Questions people ask
How can I tell if I have extension springs or torsion springs?
Look at the door from inside. Long springs running along both sides, above the horizontal tracks, are extension springs. A coil on a shaft above the door, with a cable drum at each end, is a torsion system. If you are not sure, take a photo from a safe distance and describe it when you call.
What is the thin cable that runs through my spring?
That is a safety cable. If the spring breaks, the cable keeps the pieces from flying loose. It matters because a broken extension spring can whip across the garage with force. If your springs have no cable, or it looks rusted or disconnected, mention it to the technician so it can be added or replaced.
Can I replace just one extension spring?
Usually it is better to replace both. The two springs share the load and should match in strength. A new spring paired with an old, tired one can lift unevenly and twist the door. A technician can look at the remaining spring and explain whether it is worth keeping.
Is a broken extension spring an emergency?
It is a safety concern. The door may be hard or unsafe to move, and pieces of spring can be hazardous. Stop using the opener, keep people and pets away, and call. If anyone is hurt, call 911 first. Do not try to lift the door or handle the spring yourself.
Why do my springs rust so fast?
Humidity is high for much of the year, and homes near the coast also get salt in the air. Springs are bare or lightly coated steel and show surface rust early. Rust roughens the wire and can start cracks. A technician can tell you whether it is cosmetic or a sign the springs are near the end of their life.
How do I get a quote for new extension springs?
Call and describe the door: single or double width, any windows or insulation, and what happened. A straightforward spring replacement can often be quoted by phone, with the service call charge explained before anyone is sent. More complicated work, such as adding cables or converting to torsion, needs an on-site look. Call when you are ready.
For "Extension Springs Explained", a phone call comes first. Describe the springs, the opener or the panels, and we will explain how the work is done and what the visit charge covers.
