First, make sure everyone is safe
If anyone was hurt, call 911 before anything else. A garage door damaged by a vehicle can fall, and so can the framing around it. If the vehicle is still against the door, do not move it until you know what is holding the door up. Sometimes a car is the only thing keeping a bent door from dropping, and driving away can change that.
Once everyone is accounted for, keep children and pets away from the door and the area around it. Stay out from under the door and away from the sides of the opening. A door that has been struck may have springs, cables or brackets under unusual stress, and a loose part can move without warning. Do not try to push the door back into place, lift it by hand or run the opener to see what happens.
If you are in a condominium or rental, tell the manager or landlord promptly. They may need to notify their insurer, and they may have a preferred way to handle repairs. In a shared garage entrance, other residents may be affected by a door that cannot close, so the sooner the building knows, the sooner temporary measures can be arranged.
- Call 911 if anyone is injured.
- Do not move a vehicle that may be supporting the door until it is assessed.
- Keep people and pets away from the opening.
- Do not run the opener or force the door.
Why the damage is often worse than it looks
A garage door is a system of panels, hinges, rollers, tracks, springs, cables and an opener, all working together under tension. A strike at one point sends force through all of it. A dent in a panel can mean the panel has bent at the hinge line, and a bent panel pulls on the rollers and the track. A track pushed out of line can bind the rollers and cause the door to jam. A bracket that has been pulled loose can let a cable go slack or snap.
The spring system is especially hard to judge. The springs hold the door's weight, and when a door is hit, the shaft, the center bearing plate or the end bearings can be knocked out of position. A shifted shaft puts a side load on the springs and the drums and makes the door travel crooked. You may not see that damage from the floor, and it may only show up when the door moves.
That is why a door that appears to work after an impact is not necessarily safe. A door that runs for a few cycles and then falls or jams has been given a chance to do more harm. Our page on bent tracks explains how track damage shows up and why it matters.
What you can safely check from a distance
You can learn a lot from looking. Stand outside the path of the door and observe. Is the door sitting level? Is there a gap along the side, the top or the bottom? Do any panels look folded, cracked or pushed inward? Is the track visibly bent or pulled away from the wall? Are rollers out of the track? Is a spring or a cable hanging loose, or is a bracket hanging from the panel?
Take clear photos from several angles, including close-ups of any damage and wide shots that show the whole opening. If the car is still in contact, photograph its position before it is moved. Note the date and time and write down what happened in your own words while it is fresh. If someone else was driving, record their name and contact details.
Avoid touching sharp edges, bent metal and loose parts. Torn steel can cut and glass inserts can shatter. If the door includes windows and they are broken, keep people away from the glass and sweep it carefully later with proper protection. For more on safe observation, see our guide to the garage door safety checklist.
Do not use the opener or the manual release
After an impact, it is natural to want to close the door to secure the garage. Resist that urge until the door has been checked. Running the opener on a door with a bent track or a loose cable can tear hardware from the panels, damage the opener's gears and carriage and drop a section. The opener is designed to move a balanced door, not to force one that is binding.
The manual release has its own risks. Pulling the red cord with a damaged door can let the door move without resistance, and if a spring is compromised or the door is partly open, it may fall. Use the release only when the door is fully closed and sound, and not after an impact unless a professional has told you it is safe. Our page on safe manual release use explains the rules.
If the garage must be secured right away and the door will not close safely, a technician can often make a temporary arrangement. Do not improvise with ropes, boards or wedges that hold a heavy door in place under tension, since those can fail suddenly.
Documenting the damage for insurance
If the damage may be covered by a homeowner or auto policy, good records help. Photograph the damage, the vehicle and the surrounding area before anything is moved or cleaned up. Keep a list of what was affected, such as the door, the opener, the frame, the wall, the light fixtures and anything inside the garage. Keep any damaged parts a technician removes, if possible, until the claim is settled.
A repair technician can describe what they see and what needs to be replaced, and many will provide a written statement of findings. They cannot tell you whether your insurer will pay, and they should not promise it. Coverage depends on your policy and your insurer's decisions. Contact your insurance company promptly and ask what they require.
Our guide on documenting garage door damage for a claim goes through the records worth keeping. A tidy file of photos, dates, notes and invoices makes every conversation easier.
- Photograph the door, the vehicle and the area before anything is moved.
- Write down what happened, when and who was involved.
- Contact your insurer and ask what they require.
- Keep damaged parts and all written findings and invoices.
What a technician will inspect
A technician begins with the opening itself. They look at the jambs, the header and the surrounding framing for cracks, shifts and loose fasteners. A door set into a damaged frame will not run properly even if every part of the door is new. If the frame is damaged, a carpenter or the building's maintenance team may need to repair it before the door can be set right.
Next they check the door. Each panel is examined for dents, cracks and bends, and the hinges are checked for stretched or broken knuckles. They check the rollers, the tracks and the track brackets, which are often bent or torn from the wall. They inspect the bottom brackets, cables, drums and springs, and they check the shaft for straightness and the bearings for damage. They examine the opener, its rail, carriage and mounting, and test the sensors.
They will then explain the options. A single dented panel may be replaceable if the door model is available. Several damaged panels may mean replacing the door. Bent tracks can sometimes be straightened but are often replaced. The technician should give you a clear idea of what is urgent for safety and what is cosmetic. Our page on dented panels covers when panel replacement is possible.
Repair or replace after an impact
The choice depends on how much of the door was damaged and whether matching parts are available. A door that took a light hit, with one bent track and a loose bracket, is often a good repair candidate. A door with several crushed panels, bent hardware and a shifted shaft may be better replaced, especially if it is already old and worn.
Matching is another factor. If the door is a standard style and still manufactured, a replacement section can often be found. If the door is discontinued, or the finish has faded, a new section may not match the others. In a community with appearance rules, you may need approval for a replacement that looks different.
Ask the technician for both options when they exist, along with the reasons for the recommendation. Our guide on repair versus replacement lays out the factors. If a replacement door is needed, the product approval, wind rating and any permit requirements should be discussed up front.
Impact damage in different kinds of garages
The same strike plays out differently depending on the building. In a single-family house with a standard two-car door, the damage tends to concentrate on the lower panels, the bottom brackets and the track on the side that was hit. The driveway gives the driver a straight run at the door, and the result is often a door pushed inward at the bottom with the rollers popped from the track.
In a townhome or a condominium, the garage opening may be narrower and the driveway shorter, so vehicles strike at a sharper angle. Damage may show up in the frame and the jamb as much as in the door itself. Because the frame may belong to the association, a repair can involve the building's maintenance team and the insurer for the community as well as the owner.
In a commercial setting, such as a loading bay or a shop with an overhead door, vehicles are bigger and the loads are heavier. A truck that clips a door can bend a track far out of line or damage a rolling door's guides and curtain. In those places the door may be a daily working part of the business, so the urgency is different. Our page on commercial door emergency response describes how those calls are handled.
Whatever the setting, the steps are the same: keep people safe, stop using the door, document the damage and call a professional for an inspection.
Impact damage to the opener and sensors
The opener is often forgotten in the first rush after a strike, yet it can be hurt too. The rail may be bent where the door pushed back, the carriage may be cracked, the mounting bracket on the header may be pulled out and the motor head may be knocked loose from the ceiling. If the opener's arm is attached to a bent panel, it may keep pulling at the wrong angle and damage itself on the next cycle.
Safety sensors are mounted low on each side of the opening, where a car is most likely to hit them. A bent bracket can knock a sensor out of alignment and cause the door to refuse to close or to reverse for no clear reason. A cracked sensor housing or a pulled wire can have the same effect. If the sensors have been hit, do not bypass them or try to tape or bend them into place. They are a safety feature and must work.
A technician will test the sensors and the reversal function as part of any repair. Our page on safety sensor alignment explains how they work and why alignment matters so much.
Temporary securing while you wait
If the door cannot close properly, the garage is exposed, and so is the house if it connects to the garage. Think about what is inside and what could be taken or damaged by weather or animals. Move valuables into the house if you can do so safely, and lock the interior door between the garage and the home. If your vehicle is inside and the door is open, consider whether it should be moved.
Do not attempt to hold a damaged door shut with makeshift braces. If rain or wind is expected, ask the technician about temporary measures when you call. In some cases they can secure the door or the opening so that it is safe until the repair is done. In others, they will tell you to keep the area clear and wait.
If a hurricane or tropical storm is approaching, tell the dispatcher so they can prioritize your needs. A damaged door is a weak point in a storm, and the sooner it is addressed, the better. Our page on storm preparation offers more guidance for the weeks before and during storm season.
Preventing a repeat
Most vehicle strikes happen because of a small mistake: a driver in a hurry, a car in the wrong gear, a bad sightline, a sensor that is out of line or a door that was not fully open. A few simple habits help. Wait for the door to stop before driving through. Look at the door, not just the mirror. Teach teen drivers and visitors the same habit.
Mark a stopping point inside the garage so cars do not creep forward toward the door or the wall. Keep the door's sensors clean and aligned and the opener's travel limits set correctly so the door fully opens. Consider adding bright markers or reflectors on the lower edge of the opening if sightlines are poor.
A technician can also check that the door opens to the right height. A door that stops short, even slightly, can strike a roof rack or a tall vehicle. Sometimes a small adjustment is all it takes.
What to tell us when you call
Describe what happened and what you see: whether the door is up or down, whether it moves, whether panels are bent, whether a track or spring looks out of place and whether anyone is in danger. Mention any photos and whether the vehicle is still against the door. Tell us if the garage connects to the house and if the door cannot be closed.
The dispatcher will explain the service call charge before anyone is sent, and quotes are given by phone. Complicated jobs require an on-site visit, and impact repairs often do. This site does not post prices because every case is different. We will not promise arrival times, but we will tell you what to do to keep safe while you wait.
When the technician arrives, be ready to show them what happened, share your photos and tell them about your insurance contact if there is one. They will inspect the door and explain what they find in plain language, so you can decide how to proceed.
Call before anyone uses the door again
A door that has been hit is a door you should not trust until it is checked. Keep people clear, avoid the opener and the manual release and take photos for your records. Then call and tell us what happened. We will explain the visit, the service call charge and what to expect before anyone is dispatched, and we will help you figure out the safest next step.
Questions people ask
My door still opens and closes after being hit. Is it safe?
Not necessarily. Damage to tracks, brackets, the shaft or the springs often shows up only under load, and a door that works for a few cycles may then jam or fall. Stop using it, keep people clear and have a technician inspect the whole system before the door is used again.
Will my insurance pay for the repair?
That depends on your policy and your insurer, and no repair company can promise coverage. Contact your insurance company promptly, photograph the damage and keep dated notes, invoices and any written findings. A technician can describe the damage in writing, which can help your conversation with the insurer.
Can a single dented panel be replaced?
Sometimes. If the door model is still available and the finish can be matched, one section may be replaced. If the door is discontinued, faded or has several damaged panels, replacing the door may be the better path. A technician can look at the door and explain which option is realistic.
Should I try to push the door back into place?
No. A struck door may have springs, cables or brackets under unusual stress, and forcing it can cause parts to release suddenly. Do not lift, push or run the opener. Keep people away from the opening and call for service so a technician can assess it safely.
What if I cannot close the door and a storm is coming?
Tell the dispatcher about the storm when you call so they understand the urgency. Do not use makeshift braces on a heavy door. Move valuables into the house if you can do so safely, lock the interior door from the garage and keep people away from the opening until a technician arrives.
How are prices handled for impact repairs?
Quotes are given by phone only, and impact repairs usually need an on-site visit because the full extent of damage is hard to see from a description. A service call charge applies and is explained before dispatch. There are no prices on this site because each case differs. Ask questions on the call.
If "Garage Door Hit by a Car: What to Do" is the problem at your house, call and describe what the door is doing. We explain what a repair visit would cover, and the service call charge is stated on the phone before anyone is dispatched.
